Installation Guides RSS

Ford Focus ST/RS Lower Radiator Support Installation Guide

Ford Focus ST/RS Lower Radiator Support Installation Guide

Congrats on purchasing your lower rad support! In a few short hours youll be finally free of holes in  charge pipes and loose hose clamps that cause charge pipes to leak.  Shout out to our friend Cody Souza(@cokedoutst) for the excellent how to install guide!  https://m.youtube.com/watch?v=eQ_oKOxrDLg&feature=youtu.be

Read more

Focus RS Torque Gusset Installation Guide

Focus RS Torque Gusset Installation Guide

1.) Put your vehicle in the air via a set of ramps backed up with jacks on the jack points. You'll want to have your car on ramps because the suspension must be loaded during installation. 2.) Once the vehicle is in the air, begin by removing your under tray using a t-30 torx bit. 3.) With the cover off we can see the two horizontal Lower Control Arm nuts. Remove these using an 18mm. Warning: sometimes these nuts are EXTREMELY tight. be ready with an air impact gun or your favorite redneck that runs on nicotine and hate with...

Read more

focus rs rdu brace install guide -

Ford Focus RS RDU Brace Installation Guide

Ford Focus RS RDU Brace Installation Guide

Congrats on purchasing your RDU Brace. In 45 minutes or so youll have this brace on and be ready to put the power to the wheels for your next canyon run or track day!   Step 1.) Lift the car and place it on ramps or jacks. You can just lift the rear of the car for this part   Step 2.) Locate the two oem stamped braces on the rear subfrane just below the RDU   Step 3.) Remove these braces and save the hardware.   Step 4.) Slip the brace on and reuse the oem hardware to install...

Read more

Ford Fiesta ST Crossmember Brace Installation Guide

Ford Fiesta ST Crossmember Brace Installation Guide

Congrats on purchasing your crossmember brace! In an hour youll have this brace on and be ready to tackle any back road or road course!   Step 1.) Put your car on jacks or ramps. You only need the front in the air to gain access to this area Step 2.) Locate the factory strap metal braces connecting the subframe to the unibody. These are held on by 4 bolts. Step 3.) Remove the 4 bolts using a 13mm socket wrench.  Step 4.) Slip the brace on and reinstall the oem hardware. We recommend leaving the bolts loose until all...

Read more

mazdaspeed 3 trunk brace, mazdaspeed trunk brace install guide, mazdaspeed3 adjustable trunk brace install guide -

Mazdaspeed 3 Adjustable Trunk Brace Install Guide

Mazdaspeed 3 Adjustable Trunk Brace Install Guide

Congrats on purchasing your adjustable trunk brace for your mazdaspeed 3. In about 10 minutes youll have this part installed and be ready to rip!   Step 1.) open the hatch of your car. You do not need to jack the car up for this install. Step 2.) clear out anything you have in the trunk to provide access to install. Step 3.) remove the plastic covers of the two load points right behind the seats. Use a flathead screwdriver of small knife to carefully pry the cap off. Step 4.) unbolt the load points by using a 10mm socket...

Read more

Tags