Installation Guides RSS

how to install rear mid chassis brace scion im, how to install rear mid chassis brace scion tc, how to install rear mid chassis brace scion xb, how to install rear mid chassis brace toyota corolla im -

Congrats on purchasing your TB Performance Products Rear Mid Chassis Brace! In 30 minutes to 1 hour youll be free of pesky exhaust rattles and have some added cornering grip!   Step 1.) Put your car in the air via jacks or ramps. Some people may be able to install without putting the car in the air. Step 2.) Locate the location for the brace to install to. This brace replaces the oem stamped steel unit in the exhaust tunnel. Step 3.) Remove the 4 bolts. Step 4.) Slip the brace on Step 5.) Install brace reusing the OEM hardware....

Read more

How to install TB Performance Products mid chassis brace scion tc, how to install TB Performance Products mid chassis brace scion xb, how to install TB Performance Products mid chassis brace toyota corolla im, how to install TB Performance Products scion IM -

Congrats on purchasing your TB Performance Products Mid Chassis Brace for your Scion. In one to two hours youll be out ripping the canyons and enjoying the extra grip and performance!   Step 1.) Put your car in the air via jacks or ramps. Step 2.) Locate the location for the brace to install to. You can use the pictures in my tc catalog for reference. Step 3.) Remove the 4 bolts. Step 4.) Slip the brace on Step 5.) Install brace reusing the OEM hardware. Make sure you leave all four bolts loose while installing. This will keep the...

Read more

how to install strut bar focus rs, how to install strut bar focus st -

Congrats on purchasing the best strut bar on the market for your focus! In 1-2 hours you’ll be out enjoying the improved handling, grip, and steering response that has made this strut bar the best on the market!   Step 1.) Open your hood Step 2.) locate the upper cowl. This is the area with the two vents that the windshield wipers are mounted under. Step 3.) using a torx bit unbolt this cowling. Step 4.) carefully pry off the caps for your windshield wipers. These are at the base of the wiper arm. Removing this will expose a nut....

Read more

how to install crash bar focus rs, how to install crash bar focus st -

Congrats on your new TB Performance Products Crash Bar! In 2-3 hours youll be enjoying the new look and improved performance!  Step 1: remove front bumper. This will involve removing the headlights on each side.  Step 2: with the bumper removed, disconnect horns from oem crash bar. As well as the washer fluid reservoir. One bolt on the chassis will keep the reservoir in place. You do not need to fully remove it.  Step 3: use a floor jack to come under the oem lower radiator support. Apply pressure but do not lift it. This is here to support the...

Read more

Congrats on the new TB Performance Products Crossmember brace! In around 1 hour youll be enjoying some seriously improved handling! This brace reinforces the unibody to crossmember joint. This junction is notorious for causing wallowing in corners and reducing handling. Once you get this bad boy installed youll immediately notice a difference!   Step 1.) Get your car up on either jacks or ramps. Step 2.) Locate the factory crossmember brace right where the downpipe meets with your catback. Step 3.) You can either choose to replace the factory brace or bolt the TB Performance Products Crossmember Brace over the...

Read more

Tags